Effect of Machining Condition on Surface Roughness and Hardness in Milling of AA6061 Aluminium Alloy
Authors
-
Kalyani Govt. Engineering College, Kalyani-741235, Nadia, West Bengal ,IN
Amit Banerjee -
Regent Education and Research Foundation, Barrackpore-700121, North 24 Parganas, West Bengal ,INPuspendu Chandra Chandra
-
JIS College of Engineering, Kalyani-741235, Nadia, West Bengal ,INShishir Kumar Biswas
DOI:
https://doi.org/10.24906/isc/2022/v36/i1/211806Keywords:
Cutting Velocity, Feed, Depth of Cut, Aluminium, Surface Roughness, Hardness.Abstract
Roughness of a machined surface should be as par the customer requirement to suite a particular application. For achieving the desired surface finish, appropriate values of cutting velocity, feed and depth of cut are to set, and these can be found out utilizing an optimization technique. In this study, the machining process is executed on AA6061 aluminium alloy by appling cutting fluid in a CNC milling machine and then roughness of surface and hardness are measured by a surface roughness tester and Brinell hardness tester respectively.Downloads
Downloads
Published
How to Cite
Issue
Section
References
A B Chattopadhyay, Machining and Machine Tools, Willey India Pvt. Ltd., New Delhi, India, 2012.
https://en.wikipedia.org/wiki/Surface_roughness Accessed on 11.11.2018.
S V Alagarsamy, of Influence of Turning Process Parameters on MRR & Surface Roughness Of AA7075 Using Taguchi’s Method and RSM, International Journal of Applied Research and Studies, Vol 3, page 1-8, 2014.
R Thamma, Comparison Between Multiple Regression Models to Study Effect of Turning Parameters on the Surface Roughness, Proceedings of the 2008 IAJC-IJME International Conference, Nashville, USA,2008.
H M Somashekara, Optimizing Surface Roughness In Turning Operation Using Taguchi Technique and ANOVA,International Journal of Engineering Science and Technology, Vol 04, page 1967- 1973, 2012.
M S Kumar, Optimization of Micro Milling Parameters of Al-6082 by ANOVA Methodology, Internal Journal of Mechanical Engineering and Robotics Research (IJMERR), Vol 3, page 2278 – 0149, 2014.
A Chaudhary, Optimization of Machining Parameters Affecting Surface Roughness of Al6082 in Dry End Milling Operation On VMC, International Research Journal of Engineering and Technology, Vol 04, page 82-89, 2017.
M S Najiha, Modeling of The End Milling Process for Aluminium Alloy Aa6061t6 Using HSS Tool, International Journal of Automotive and Mechanical Engineering, Vol 8, page 1140-1150, 2013.
I Asilturk, Multi Response Optimization Of CNC Turning Parameters Via Taguchi Method-Based Response Surface Analysis, Measurement, Vol45, page 785-794, 2012.
A Bhattacharya, Estimating the Effect of Cutting Parameters on Surface Finish and Power Consumption During High Speed Machining of AISI 1045 Steel Using Taguchi Design and ANOVA, Production Engineering Research and Development, page 31-40, 2009.
