Influence of Structural Discontinuity on Slope Stability using Numerical Modelling and Sirovision
Authors
-
Associate Professor, Department of Mining Engineering, Dr. T. Thimmaiah Institute of Technology, KGF, Robertsonpet - 563120, Karnataka ,IN
S. Raja -
Former Professor (HAG), Department of Mining Engineering, NITK, Surathkal, Mangaluru - 575025, Karnataka ,INCh. S. N. Murthy
DOI:
https://doi.org/10.18311/jmmf/2024/34911Keywords:
Discontinuities, Joint Properties, Plaxis, Sirovision, Slope StabilityAbstract
The rock mass consists of heterogeneous and anisotropic materials, with smaller and larger blocks of rock, and the presence of structural discontinuities is a significant concern. Characterising the rock mass is crucial for the success of engineering excavations in such areas. A detailed study of joints, their orientation, and discontinuities in the exposed rock mass is crucial as they greatly influence stability and fragmentation. Existing rock mass classifications like Rock Mass Rating (RMR) and Q-classification require various geological parameters and physico-mechanical properties of the rock. However, determining these parameters conventionally can be time-consuming, requiring careful on-site measurements. The number of opencast coal mines is increasing compared to underground mines due to shorter gestation periods, higher productivity, and quicker returns. However, opencast mining raises environmental concerns such as air and water pollution, solid waste management, land degradation, and socio-economic issues. Additionally, many opencast coal mines, regardless of size, are reaching greater depths, making analysing bench slopes and ultimate pit slope design crucial. Slope failure in these mines leads to production loss, additional costs for recovery and handling of failed material, pit dewatering, sometimes mine abandonment or premature closure, and loss of life. A study was conducted at Prakash Khani Opencast Mine – IV, Manuguru area, M/s The Singereni Company Collieries Limited (SCCL), to investigate the influence of structural discontinuities on slope stability. SIROVISION software was used to assess rock mass characterisation, while PLAXIS-2D software was employed to analyse the influence of structural discontinuities on slope stability. A comparative conclusion was drawn based on the results obtained from SIROVISION and PLAXIS-2D analyses. The study revealed that the RMR of the mine ranged from very poor to fair due to numerous discontinuities. It was also found that discontinuities in the slope decrease the Factor of Safety (FOS), indicating an impact on slope stability.
Downloads
Metrics
Downloads
Published
How to Cite
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Accepted 2024-03-06
Published 2024-03-29
References
Abramson LW, Lee TS, Sharma S, Boyce GM. Slope stability concepts and slope stabilisation and stabilisation methods. Second edition, published by John Willey and Sons, Inc. 2002; 329-461.
Abramson LW. General slope stability concepts. John Wiley and Sons, eds., New York. 2001; 1-36.
Zhu M. Slope stability of open pit mine on finite difference method. Proc of Second International Conference on Information and Computer Science, Manchester. 2009; DOI: https://doi.org/10.1109/ICIC.2009.258
:208-11. https://doi.org/10.1109/ICIC.2009.258 4. Bisleshana BP. Design of stable slope for opencast mines. B. Tech Thesis, Department of Mining Engineering, NIT Rourkela. 2009; 58.
Charanpreet SF. Evaluation of slope stability for waste dump in mine. B. Tech Thesis, Department of Mining Engineering, NIT Rourkela; 2009. p. 56.
Jami MG, McHugh E. Detecting problems with mine slope stability. National Institute for Occupational Safety and Health, Spokane Research Laboratory. Proceedings of the Thirty-first Annual Institute on Mining Health, Safety and Research, Roanoke, Virginia, Bockosh GR, Karmis M, Langton J, McCarter MK, Rowe B, eds., Blacksburg, VA: Virginia Polytechnic Institute and State University; 2000. p. 147-55.
Palmstrom A. The volumetric joint count - a useful and simple measure of the degree of rock mass jointing. Proc of IV Congress International Association of Engineering Geology, New Delhi. 1982; 2:120-30.
Hoek E, Bray JW. Rock slope engineering. Chapman and Hall, New York; 1994. p. 354.
Hoek E, Brown ET. Underground excavations in rock. Chapman and Hall, New York; 1994. p. 526.
Sirovision. www.csiro.com/au/sirovision (last visited on Mar 3, 2023).
Plaxis. Reference manual. Plaxis BV, the Netherlands. 2006; 30.
Sainsbury DP, Pierce ME, Lorig LJ. Two and threedimensional numerical analysis of the interaction between open pit slope stability and remnant underground voids. Proc of Fifth Large Open Pit Mining Conference, Itasca Australia Pty Ltd. 2003; 251-7.
Bieniawski ZT. Rock mass classifications in rock engineering. Proc Symp on Exploration for Rock Engineering, Johannesburg. Ed. Bieniawski. Publ Balkema, Rotterdam. 1986; 97-106.
Barton NR. Suggested methods for the quantitative description of discontinuities in rock masses. Int J of Rock Mech Min Sci and Geomech. 1978; 15(1):319-68.
