Green Synthesis, Characterization and Electrical Properties of Iron Doped Vanadium Oxide for Strain Gauges

Jump To References Section

Authors

  • T. R. Kishan Chand
     Department of Electronics and Instrumentation Engineering, Siddaganga Institute of Technology, Tumakuru572103, Karnataka ,IN
  • H. M. Kalpana
     Department of Electronics and Instrumentation Engineering, Siddaganga Institute of Technology, Tumakuru572103, Karnataka ,IN
  • H. S. Lalithamba
     Department of Chemistry, Siddaganga Institute of Technology, Tumakuru-572103, Karnataka ,IN

DOI:

https://doi.org/10.18311/jmmf/2022/32031

Keywords:

Nanoparticles, Vanadium Oxide, Iron, Electrical Properties, Strain Gauge.

Abstract

A series of vanadium oxide (V2O5) nanoparticles containing small varying concentrations of iron (Fe) were synthesized using green protocol to test its suitability towards strain gauges. The morphological, structural, transmission spectral and the dielectric properties of the synthesized nanoparticles were characterized using SEM, HRTEM, XRD, FTIR and the LCR meter respectively. The structural analysis results depict a transformation from amorphous to orthorhombic cubic phased crystalline structure. The morphological data denote an improvement in the appearance of the samples without any cracks. A better electronic transition due to high activation energy was observed from the slight shift of the transmission spectral peaks towards the lower wave number. The improved conductivity from 5.37 to 12.51 S/m in conjunction with the better temperature characteristics, specially incase of 15 wt% Fe:V2O5 contributes to the enhanced sensitivity of the samples. The overall results from the characterization emphasize the synthesized nanoparticle’s remarkable attributes towards the fabrication of thin film strain gauges.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2022-12-08

How to Cite

Kishan Chand, T. R., Kalpana, H. M., & Lalithamba, H. S. (2022). Green Synthesis, Characterization and Electrical Properties of Iron Doped Vanadium Oxide for Strain Gauges. Journal of Mines, Metals and Fuels, 70(8A), 135–143. https://doi.org/10.18311/jmmf/2022/32031

Issue

Volume 70, Issue 8A, August 2022

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Crossref
Scopus
Google Scholar
Europe PMC

 

References

Zhao, Yinming, Yang Liu, Yongqian Li, and Qun Hao. (2020): “Development and application of resistance strain force sensors.” Sensors, 20, no. 20, p.5826. DOI: https://doi.org/10.3390/s20205826

O.O. Oluwole, A. T. Olanipekun, and O.O. Ajide. (2015): “Design, construction and Testing of a strain gauge Instrument.” Int. J. Sci. Eng. Res, 6, pp. 1825-1829.

Tutak, Piotr. (2014): “Application of strain gauges in measurements of strain distribution in complex objects.” Journal of Applied Computer Science Methods, 6. DOI: https://doi.org/10.1515/jacsm-2015-0004

Carofiglio, Marco, Sugata Barui, Valentina Cauda, and Marco Laurenti. (2020): “Doped zinc oxide nanoparticles: synthesis, characterization and potential use in nanomedicine.” Applied Sciences, 10, no. 15, p. 5194. DOI: https://doi.org/10.3390/app10155194

Liang Xing, Guohua Gao, Yindan Liu, Tianqi Zhang, and Guangming Wu. (2017): “Synthesis and characterization of Fe-doped vanadium oxide nanorods and their electrochemical performance.” Journal of Alloys and Compounds, 715. DOI: https://doi.org/10.1016/j.jallcom.2017.04.242

Zhang, Yanqing, Weiming Xiong, Weijin Chen, and Yue Zheng. (2021): “Recent progress on vanadium dioxide nanostructures and devices: fabrication, properties, applications and perspectives.” Nanomaterials, 11, no.2, p.338. DOI: https://doi.org/10.3390/nano11020338

Li Yanwei, Jinhuan Yao, Evan Uchaker, Ming Zhang, Jianjun Tian, Xiaoyan Liu, and Guozhong Cao. (2013): “Sn-doped V2O5 film with enhanced lithium-ion storage performance.” The Journal of Physical Chemistry C, 117, 45, pp.23507-23514. DOI: https://doi.org/10.1021/jp406927m

A Salimian, S. Ketabi, and H. R. Aghabozorg. (2018): “Hydrogen storage comparison of M doped vanadium oxide nanotubes (M=Mo, Zr and W): A molecular simulation study.” International Journal of Hydrogen Energy, 43, no. 5, pp. 2831-2839. DOI: https://doi.org/10.1016/j.ijhydene.2017.12.017

M. Farahmandjou, and N. Abaeiyan. (2017): “Chemical synthesis of vanadium oxide V2O5 nanoparticles prepared by sodium metavanadate.” Journal of Nanomedicine Research, 5, no. 1. DOI: https://doi.org/10.15406/jnmr.2017.05.00103

Kianfar, Ehsan. (2019): “Recent advances in synthesis, properties, and applications of vanadium oxide nanotube.” Microchemical Journal, 145, pp. 966-978. DOI: https://doi.org/10.1016/j.microc.2018.12.008

Venkatesan, Arumugam, Nagamuthu Raja Krishna Chandar, Arumugam Kandasamy, Madhu Karl Chinnu, Kalusalingam Nagappan Marimuthu, Rangasamy Mohan Kumar, and Ramasamy Jayavel. (2015): “Luminescence and electrochemical properties of rare earth (Gd, Nd) doped V2O5 nanostructures synthesized by a non-aqueous sol–gel route.” RSC Advances, 5, no. 28, pp. 21778-21785. DOI: https://doi.org/10.1039/C4RA14542A

Zhou, Xiao-xia, Jing-fu Liu, and Gui-bin Jiang. (2017): “Elemental mass size distribution for characterization, quantification and identification of trace nanoparticles in serum and environmental waters.” Environmental Science & Technology, 51, no. 7, pp. 3892-3901. DOI: https://doi.org/10.1021/acs.est.6b05539

Gnanasambanthan, Harish, Sharmila Nageswaran, and Debashis Maji. (2019): “Fabrication of Flexible Thin Film Strain Sensors using Kapton Tape as Stencil Mask.” International Conference on Vision towards Emerging Trends in Communication and Networking (ViTECoN), IEEE, pp. 1-4. DOI: https://doi.org/10.1109/ViTECoN.2019.8899456

Rida A, Micoulaut M, Rouhaud E, & Makke, A. (2020): “Understanding the strain rate sensitivity of nanocrystalline copper using molecular dynamics simulations.” Computational Materials Science, 172, p. 109294. DOI: https://doi.org/10.1016/j.commatsci.2019.109294

Alghool, Samir, Hanan F. Abd El- Halim, and Ayman M. Mostafa. (2019): “An eco-friendly synthesis of V 2 O 5 nanoparticles and their catalytic activity for the degradation of 4-nitrophrnol.” Journal of Inorganic and Organometallic Polymers and Materials, 29, no. 4, pp. 1324-1330. DOI: https://doi.org/10.1007/s10904-019-01096-1

Ealia S and M. P. Saravanakumar. (2017): “A review on the classification, characterisation, synthesis of nanoparticles and their application.” In IOP Conference Series: Materials Science and Engineering, 263, no. 3, p. 032019. DOI: https://doi.org/10.1088/1757-899X/263/3/032019

A. Jagadeesh, T. Mimani Rattan, M. Muralikrishna, and K. Venkataramaniah. (2014): “Instant one step synthesis of crystalline nano V2O5 by solution combustion method showing enhanced negative temperature coefficient of resistance.” Materials Letters, 121, pp. 133-136. DOI: https://doi.org/10.1016/j.matlet.2014.01.080

Chaitra. C, H. M. Kalpana, C. M. Ananda, and H. S. Lalithamba. (2022): “Green synthesis of tin oxide based nanoparticles using Terminalia bellirica seed extract: impact of operating temperature and antimony dopant on sensitivity for carbon dioxide gas sensing application.” Materials Technology, pp. 1-8. DOI: https://doi.org/10.1080/10667857.2022.2035143

M. Liu Xuyan, Jiahuan Zeng, Huinan Yang, Kai Zhou, and Deng Pan. (2018): “V2O5-based nanomaterials: synthesis and their applications.” RSC advances, 8, no. 8, pp. 4014-4031. DOI: https://doi.org/10.1039/C7RA12523B

Latif, Muhammad Moazzam, Faheem Amin, Muhammad Ajaz-un-Nabi, Ikram-ullha Khan, and Nadeem Sabir. (2021): “Synthesis and antimicrobial activities of manganese (Mn) and iron (Fe) Co-Doped cerium dioxide (CeO2) Nanoparticles.” Physica B: Condensed Matter, 600, p. 412562. DOI: https://doi.org/10.1016/j.physb.2020.412562

Ali, Attarad, Muhammad Zia Hira Zafar, Ihsan ul Haq, Abdul Rehman Phull, Joham Sarfraz Ali, and Altaf Hussain. (2016): “Synthesis, characterization, applications, and challenges of iron oxide nanoparticles.” Nanotechnology, science and applications, 9, no. 49. DOI: https://doi.org/10.2147/NSA.S99986

Leal L. R. F, Y. Guerra, E. Padrón- Hernández, A. R. Rodrigues, F. E. P. Santos, and R. Peña-Garcia. (2019): “Structural and magnetic properties of yttrium iron garnet nanoparticles doped with copper obtained by sol gel method.” Materials Letters, 236, pp. 547-549. DOI: https://doi.org/10.1016/j.matlet.2018.11.004

Y. Veeraswamy, Y. Vijayakumar, and R.R. Reddy. (2014): “Growth and Micro Structural Characterization of In2O3 Thin Films Prepared by Electron Beam Evaporation Technique.” Journal of Research in Engineering and Technology, 5. pp. 267-272. DOI: https://doi.org/10.15623/ijret.2015.0419002

Praveenkumar K, T. Sankarappa, J. S. Ashwajeet, and R. Ramanna. (2015): “Dielectric and AC conductivity studies in PPy-Ag nanocomposites.” Journal of Polymers. DOI: https://doi.org/10.1155/2015/893148